data terminal equipment การใช้

• Units which are the last receiver or generate data are called hosts or data terminal equipment.
• Typically, the DTE port provides timing to the data terminal equipment while the WAN port dictates the rate.
• Serial port B was wired as a Data Terminal Equipment ( DTE ) port and had no modem control.
• Data to be transmitted are transferred to a modem from Data terminal equipment ( e . g . a computer ).
• Burst transmission, however, enables communications between data terminal equipment ( DTEs ) and a data network operating at dissimilar data signaling rates.
• SVCs are used in situations where data transmission is sporadic and / or not always between the same data terminal equipment ( DTE ) endpoints.
• The data terminal equipment may be a single piece of equipment or an interconnected subsystem of multiple pieces of equipment that perform all the required functions necessary to permit users to communicate.
• The current revision is " TIA-232-F Interface Between Data Terminal Equipment and Data Circuit-Terminating Equipment Employing Serial Binary Data Interchange ", issued in 1997.
• The current version of the standard is " TIA-232-F Interface Between Data Terminal Equipment and Data Circuit-Terminating Equipment Employing Serial Binary Data Interchange ", issued in 1997.
• The full title of the standard is " EIA-449 General Purpose 37-Position and 9-Position Interface for Data Terminal Equipment and Data Circuit-Terminating Equipment Employing Serial Binary Data Interchange ".
• The NTN identifies the exact network device ( DTE, data terminal equipment ) in the packet-switched network ( PSN ) and is often provided as an NUA . There are no rules to the structure of the NTN.
• Burst transmission in isochronous form enables communication between data terminal equipment ( DTE ) and data networks that operate at dissimilar data signaling rates, such as when the information-bearer channel rate is higher than the DTE output data signaling rate.